USB-C for Engineers, Part 2 — Reclaimer Labs
USB Type-C/PD Brief Introduction and Analysis | Richtek Technology
USBREG — USB regulator control
USB Made Simple - Part 2
Reclaimer Labs
Impact of Ground Differential on USB HS Operation
USB Type-C Circuit Protection | DigiKey
USB Wire Color Code - The Four Wires Inside | Color coding, Usb, Electronics basics
Electrical issue with USB ? Hi-speed device not working on own design - Electrical Engineering Stack Exchange
power supply - Pin of micro USB connector in Smartphone - Electrical Engineering Stack Exchange
Battery Charging with USB - Developer Help
How To Connect The AVR32-UC3B
USB Back Voltage
USB-C for Engineers, Part 2 — Reclaimer Labs
![USB charging, part 1: requirements [LWN.net]](https://static.lwn.net/images/2016/usb-prc-sm.png "USB charging, part 1: requirements [LWN.net]")
USB charging, part 1: requirements [LWN.net]
MPQ4228-C-AEC1 | 36V, 3A, Step-Down Converter with USB Charging Port Supporting CDP and Type-C 5V @ 3A DFP Mode, AEC-Q100 Qualified | MPS
High voltage protection for USB transceivers in 45nm CMOS | Semantic Scholar
What is the exact voltage of a standard USB data signal in either data wire? I'd assume they are the same. I know that the power wires are 5 volts. - Quora
RT1738 - Type-C CC and SBU Short to VBUS Over-Voltage and IEC ESD Protection Switch | Richtek Technology
To what voltage should the D+ line be pulled up when designing USB connection in STM32? +5V or +3.3V? All documentation and dev board scematics says it's 3.3V, but it didn't work.
stm32 - STM32F072C8 - USB communication issue - Electrical Engineering Stack Exchange
STM32F4 USB FS and PA8 as output not working
USB in a NutShell - Chapter 2 - Hardware
TPS25830-Q1: DM and DP communicate with host directly without passing through USB switch inside the chip - Interface forum - Interface - TI E2E support forums
STUSBCD01B - USB charger detection interface - STMicroelectronics
3.5. USB — Ka-Ro electronics GmbH documentation
